HOW ESTROTECT™ WORKS – AGHOLD

HOW ESTROTECT™ WORKS

ESTROTECT Instructional Video

KEEP BREEDING INDICATORS WARM

ESTROTECT™ Breeding Indicators should be warmed to 100ºF or 38ºC immediately prior to application to activate adhesive. ESTROTECT Breeding Indicators should be soft and flexible at application for optimal adhesion.

Small quantities (less than 5 Breeding Indicators) may be warmed inside clothing. For large quantities, put the Breeding Indicators in a small cooler with a hot water bottle or other heat source, as this is more effective and consistent.

Note: The ESTROTECT Breeding Indicator should always be soft and flexible at application for optimal adhesion.

CHOOSE SITE OF APPLICATION

Ideal location for placement on the cow is halfway between the hip and tail head with the ESTROTECT Breeding Indicator evenly spaced perpendicular to the spine.

Note: Protect Breeding Indicators from tail flicking by placing them near the top of the tail when fly counts are high.

BRUSH HAIR THOROUGHLY

Vigorously brush with the grain of the coat across the backbone on the back half of the cow to remove dirt, dust and shedding hair. The ESTROTECT Rubber Brush is recommended, as it does not raise excess dust and oil.

Note: Do NOT brush hair with a steel bristle comb. Do not use stiff curry combs for brushing or cleaning.

CLEAN THE HAIR

Clean the surface area with an ESTROTECT Cleaning Cloth to remove any remaining dirt, dust, sand or sawdust. A painter tack cloth may also be used as an alternative.

APPLY THE BREEDING INDICATOR

Place Breeding Indicator on the application site halfway between the hip and tail head. Press down firmly and rub into hair with bare fingers. Do not apply in rainy weather conditions.

CHECK FOR RESULTS

As mounting activity occurs, the ESTROTECT Breeding Indicator’s silver and black surface ink – featuring the NEW Breeding Bullseye – is rubbed off by the friction of the mounting and will reveal the indicator color (red/orange, green, blue, yellow or fuchsia).

With each mount, the silver and black surface ink will gradually reveal the indicator color indicating a true standing heat. Once the black Breeding Bullseye is rubbed off, or the equivalent surface area, this indicates the animal is in standing heat and the breeding protocol should be initiated.

Estrus intensity is the level of standing heat a cow or heifer is displaying. This indicates the strength of fertility she’s expressing at that time. In general, more mounting activity means higher estrus intensity and fertility. Higher estrus intensity leads to increased pregnancy rates and lower pregnancy loss rates.

ESTROTECT™ unveils new, industry-shifting Breeding Indicator for dairy and beef Producers - October 1st, 2018

Preparing replacement heifers for the long run - May 27th, 2020

Evaluation of a modified GnRH-based timed-AI protocol associated with estrus detection in beef heifers inseminated with sex-selected or conventional semen - September 26th, 2018

Contact us:

E-mail: info@aghold.co.za

Orders: +27 (0) 83 400 4055 / tracey@aghold.co.za

Technical: +27 (0) 71 390 4941 / ian@aghold.co.za

Estrotect, As Good As A Bull and Breeding Bullseye are Trademarks of Rockway, Inc.